Knocking noise from moonroof
#401
The TSB just has them cleaning the rubber seals and applying Krytox grease. No replacement of any parts. This reminds me of my C6 vette with a creaking popping top that Chevrolet never fixed. Here we go again...
#402
#403
Junior Member
and just 60 miles later after the engineer looked at the moonroof on friday and they did their clean glass, tighten bolt fix, the knocking is back in less than 60 miles. So i have the two front seats that won't push cold air, the doors that don't shut when closed without opening and slamming three times, the door latches that knock going down the road and a moonroof that knocks at me constantly.....$65k!
How hard is it for a company that mass produces trucks and chargers high dollar for them to get a fix and stop the bs we are all going through.
Just venting because i can't stand to think about going to the dealership again and tell them the same stuff is still broke!
How hard is it for a company that mass produces trucks and chargers high dollar for them to get a fix and stop the bs we are all going through.
Just venting because i can't stand to think about going to the dealership again and tell them the same stuff is still broke!
if i were you i would get a lawyer ford will buy the truck back.
#404
I had my platinum in again last week to my original dealer and the service tech stated he adjusted and lubricated the vent shade arms and since then everything has been quiet. The sales manager that I've been buying from for the last 20 years or so offered me a deal that I couldn't refuse so tomorrow I'm picking up a new 2016 Platinum Metallic loaded. We'll see how that works out.
#405
Junior Member
Join Date: Sep 2015
Location: Eastern Shore Of Virginia
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Had my 2015 platinum in for service at my local Ford dealer Monday and the tech as well as the service manager both aknowledged that the noise was there and unacceptable. After consultation with Ford they are going to apply grease etc. as per the TSB currently in place. I'm not very hopeful that this will cure the problem though as I think Ford is still trying to figure out the real fix. I had a first generation 4 door Raptor with a slip yoke hang up problem and at first they applied a different grease to the splines on the drive shaft with a small improvement. Eventually they replaced the drive shaft completely solving the problem. Could be same scenario at work here. We shall see. Do I have a bowtie in my future? Hope not but we shall see.
#406
Had my 2015 platinum in for service at my local Ford dealer Monday and the tech as well as the service manager both aknowledged that the noise was there and unacceptable. After consultation with Ford they are going to apply grease etc. as per the TSB currently in place. I'm not very hopeful that this will cure the problem though as I think Ford is still trying to figure out the real fix. I had a first generation 4 door Raptor with a slip yoke hang up problem and at first they applied a different grease to the splines on the drive shaft with a small improvement. Eventually they replaced the drive shaft completely solving the problem. Could be same scenario at work here. We shall see. Do I have a bowtie in my future? Hope not but we shall see.
#407
Senior Member
FWIW, there are a few folks on this forum that have lubed their sunroof and solved their problem prior to the TSB. Hopefully this solves the issue without any major reconstruction.
#408
I lubed mine generously with the Meguires product mentioned above 3 different times & it did nothing for my rattling.
#409
Senior Member
#410
I have the Meguires 40 product. While I'm sure it's a fine product for certain applications there is absolutely no comparison between that and the Rotunda Krytox Grease (Part #164-R4906) in terms of viscosity and lubricating qualities. Also please note that Step 9 (figure 4) of TSB 16-0020 also calls for greasing the "openings of the left and right set plates." Meguires can't do that, only the noted grease can. I would certainly try the TSB using everything as they describe. Worse case is you pay for the grease and it doesn't work. The grease is about $15 for a 1/4 oz. tube. Good luck.
The following users liked this post:
TeamTee (02-27-2016)