Bent axle ? help please
#21
![Default](https://www.f150forum.com/images/icons/icon1.gif)
Can anyone point me in the right direction for new bearings and seals? ive found the drive shaft, and the axle shaft , ive found the bearing puller and the hammer puller.. just need a link or part number for bearings and seals.
I just watched a video on the entire proces,, pretty straight forward. ive ordered the spcialty tools.. shoud l replace both bearings seals, and shafts with new pieces jsut to be sure.?
thankyou
I just watched a video on the entire proces,, pretty straight forward. ive ordered the spcialty tools.. shoud l replace both bearings seals, and shafts with new pieces jsut to be sure.?
thankyou
Last edited by SaltyBill; 06-29-2024 at 11:28 AM.
#22
![Default](https://www.f150forum.com/images/icons/icon1.gif)
Im orderign the axle shafts from rock auto.
there are 2 different typres of axle shafts,.
8.8 USA Standard gear and
8.8 FOR SUPER 8.8 34 spline\
which do i have ? i have a 4x4 with Electronic rear locker diff.
Also the Rear seals..? can someone please point out me which i should buy on rocak auto. im confused.
Also with the bearings ? please.
thankyou
there are 2 different typres of axle shafts,.
8.8 USA Standard gear and
8.8 FOR SUPER 8.8 34 spline\
which do i have ? i have a 4x4 with Electronic rear locker diff.
Also the Rear seals..? can someone please point out me which i should buy on rocak auto. im confused.
Also with the bearings ? please.
thankyou
#23
![Default](https://www.f150forum.com/images/icons/icon1.gif)
It looks like the rear axle bearings are out of stock at rock auto.
For the seal I would get the Timken 100357.
All of the axle shafts listed are for the super 8.8, which you have, all listed 34 spline, your choice as far as brand/cost, don't think you could go wrong with either.
For the seal I would get the Timken 100357.
All of the axle shafts listed are for the super 8.8, which you have, all listed 34 spline, your choice as far as brand/cost, don't think you could go wrong with either.
The following users liked this post:
SaltyBill (06-29-2024)